Forced Starting of Display: Notes

Special Tools Required 

SCS service connector 07PAZ-0010100

1. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode
2. Remove the right side kick panel (see TRIM REMOVAL/INSTALLATION - DOOR AREAS )
3. Connect the SCS service connector (A) to the navigation service connector (B) located by the passenger's kick panel
   Fig 1: Connecting SCS Service Connector To Navigation Service Connector

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode
5. Check that the diagnosis menu for the picture diagnosis starts up, and then changes to the system link menu
   NOTE: If the display fails to display the system link screen, refer to no picture is displayed (see No picture is displayed )