DTC B1006: MICU Lost Communication with Door Multiplex Control Unit (Door Lock Switch Message)
WARNING: This page is about a different car, the 2008 Acura TSX, 2007 Acura TSX, 2006 Acura TSX, 2005 Acura TSX, and 2004 Acura TSX. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN system diagnosis Test Mode A (see TROUBLESHOOTING - B-CAN SYSTEM DIAGNOSIS TEST MODE A
).
- Clear the DTCs using the HDS.
- Cycle the ignition switch to OFF, and then back ON.
- Check for DTCs using the HDS.
Is DTC B1006 indicated ?
YES -Go to step 4.
NO -Intermittent failure, the door multiplex control unit is OK at this time. Check for loose or poor connections. If the connections are good, check the battery condition (see BATTERY TEST ) and the charging system (see CHARGING SYSTEM INDICATOR CIRCUIT TROUBLESHOOTING ).
- Check for DTCs in the gauge control module and relay module using the HDS.
Are DTCs B1160 and B1058 also indicated?
YES -Go to DOOR MULTIPLEX CONTROL UNIT INPUT TEST .
NO -Check for an open, or a short to power or ground in the communication circuit between the MICU and the door multiplex control unit. If the circuit is OK, replace the MICU. If the circuit is bad, repair the open, or short to power or ground.