LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Acura >> 2010 >> TL Base >> Repair and Diagnosis >> Engine Performance >> Testing & Diagnosis >> Electronic Throttle Control System >> Accelerator Pedal Module Removal and Installation >> Removal
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Accelerator Pedal Module Removal and Installation: Removal

  1. Remove the driver's dashboard undercover (see DRIVER'S DASHBOARD UNDERCOVER REMOVAL/INSTALLATION )
  2. Disconnect the APP sensor 6P connector (A)
    Fig 1: Identifying APP Sensor 6P Connector, Mounting Nuts, Clip And Pedal Stop
    G05987526Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove the two mounting nuts (B), then remove the clip (C) Using a flat-tip screwdriver (D), push the lock (E), then remove the accelerator pedal pad (F) from the pedal stop (G)
  4. Remove the accelerator pedal module
    NOTE:
    • The APP sensor is not available separately Do not disassemble the accelerator pedal module
    • If the pedal stop is damaged, replace it by pulling back the carpet (A), and removing the nuts (B), the bolt (C), and the pedal stop (D)
      • Fig 2: Carpet, Nuts, Bolt And Pedal Stop With Torque Specification
      G05987527Courtesy of AMERICAN HONDA MOTOR CO., INC.
scientia non olet · About LEMON Manuals