DTC B1147: Left Rear Window Position Data Error; DTC B1149: Right Rear Window Position Data Error
NOTE:
- If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A (see TROUBLESHOOTING - B-CAN SYSTEM DIAGNOSIS TEST MODE A ).
- Information marked with an asterisk (*) applies to the right rear power window.
- Clear the DTCs with the HDS.
- Turn the ignition switch to LOCK (0) and then back to ON (II).
- Open and close the left (right)* rear power window by using the left (right)* rear power window switch manually.
- Check for DTCs with the HDS.
Is DTC B1132 or B1133 (B1133 or B1134)* also indicated?
YES -Troubleshoot the indicated DTC(s) first.
NO -Go to step 5.
- Reset the power window control unit (see RESETTING THE POWER WINDOW CONTROL UNIT ).
- Clear the DTCs with the HDS.
- Turn the ignition switch to LOCK (0) and then back to ON (II).
- Open and close the left (right)* rear power window by using the left (right)* rear power window switch manually.
- Check for DTCs with the HDS.
Is DTC B1147 (B1149)* indicated?
YES -Go to step 10.
NO -The system is OK at this time.
- Turn the ignition switch to LOCK (0).
- Substitute a known-good left (right)* rear power window switch.
- Clear the DTCs with the HDS.
- Turn the ignition switch to LOCK (0) and then back to ON (II).
- Open and close the left (right)* rear power window by using the left (right)* rear power window switch manually.
- Check for DTCs with the HDS.
Is DTC B1147 (B1149)* indicated?
YES -Faulty the left (right)* rear power window motor; replace left (right)* rear door regulator (see REAR DOOR GLASS, QUARTER GLASS, AND REGULATOR REPLACEMENT ).
NO -Replace the left (right)* rear power window switch (see POWER WINDOW MASTER SWITCH REPLACEMENT ).