Wheel Speed Sensor Inspection: Notes
NOTE:
The outer board joint must be removed to inspect the magnetic encoder.
- Front driveshaft removal (see DRIVESHAFT INSPECTION ).
- Rear driveshaft removal (see REAR DRIVESHAFT REMOVAL ).
- Clean the magnetic encoder, and make sure no metal or other debris is stuck to the magnetic encoder surface.
- Check the magnetic encoder (A) for damage. If cracked or damaged, replace the encoder (wheel bearing).
- Front hub bearing unit replacement (see KNUCKLE/HUB BEARING UNIT REPLACEMENT ).
- Rear hub bearing unit replacement (see KNUCKLE/HUB BEARING UNIT REPLACEMENT ).