LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Acura >> 2011 >> RL >> Repair and Diagnosis >> General Information >> Reset Procedures >> Tire Pressure Monitor Systems >> TPMS Reset Procedures >> Pax System Reset
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Pax System Reset

NOTE: On models equipped with PAX tire systems, if a tire is repaired or replaced, the warning indicator (and the mileage counter that supports it) must be reset, no matter how far the vehicle was driven in the run flat mode.
  1. To put the gauge control module into the self-diagnostic mode, perform the following:
    • Turn the headlight switch to ON.
    • Press and hold the "SELECT" or appropriate switch (2005-06 Instrument Panel Brightness, 2007-08 Select/Reset Info Switch).
    • Turn the ignition switch to ON (II).
    • Within 5 seconds, turn the headlights to OFF, then to AUTO, and then to OFF again (2005-06 models: ON-OFF-ON).
    • Within 5 seconds, release the "SELECT" or appropriate knob, then push and release the knob three times.
  2. Once the gauge control module is in the self-diagnostic mode, press and hold the INFO button on the steering wheel for 5 seconds to get to the CUSTOMIZE MENU.
  3. Use the INFO button to scroll through to the PAX RESET screen, then press the SEL/RESET button on the steering wheel.
  4. Use the INFO button to scroll to the appropriate wheel, and then press the SEL/RESET button on the steering wheel to reset the PAX warning system display. The screen should read "PAX RESET COMPLETED". Repeat this step for each wheel that needs to be reset.
  5. Use the INFO button to scroll through to EXIT, then press the SEL/RESET button.
  6. Turn the ignition switch to OFF to exit the self-diagnostic mode.
scientia non olet · About LEMON Manuals