TPMS Control Unit Replacement

NOTE: Make sure the TPMS control unit mounting base is not bent or twisted as this may affect communication with the indicators and the tire pressure sensors.

Make sure the ignition switch is in LOCK (0).
Remove the rear shelf (see TRIM REMOVAL/INSTALLATION - REAR SHELF AREA ).
Disconnect the TPMS control unit connectors (A).

Fig 1: Disconnecting TPMS Control Unit Connectors With Torque Specifications
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the TPMS control unit (B).
Install the TPMS control unit in the reverse order of removal.
Connect the HDS, and memorize the pressure sensor IDs (see MEMORIZING THE TIRE PRESSURE SENSOR ID ). Do not memorize the IDs automatically.