Brake Pedal Position Switch Signal Circuit Troubleshooting
- Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode
- Check the BRAKE SWITCH in the DATA LIST with the HDS
Does it indicate OFF?
YES -Go to step 3
NO -Inspect the brake pedal position switch (see BRAKE PEDAL AND BRAKE PEDAL POSITION SWITCH ADJUSTMENT )
- Press the brake pedal, and check the BRAKE SWITCH in the DATA LIST with the HDS
Does it change to ON?
YES -The brake pedal position switch signal circuit (BKSW line) is OK
NO -Go to step 4
- Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode
- Jump the SCS line with the HDS
- Disconnect the brake pedal position switch 4P connector
- Disconnect PCM connector A (49P)
- Check for continuity between PCM connector terminal A8 and body ground
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Is there continuity?
YES -Repair short in the wire between the PCM (A8) and the brake pedal position switch Also replace the No 10 HORN/STOP (20 A) fuse in the under-hood fuse/relay box
NO -Go to step 9
- Connect brake pedal position switch 4P connector terminal No 2 to body ground with a jumper wire
- Check for continuity between PCM connector terminal A8 and body ground
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Is there continuity?
YES -Repair open in the wire between the brake pedal position switch, and also replace the No 10 HORN/STOP (20 A) fuse in the under-hood fuse/relay box Inspect the brake pedal position switch (see BRAKE PEDAL AND BRAKE PEDAL POSITION SWITCH ADJUSTMENT )
NO -Repair open in the wire between the PCM (A8) and the brake pedal position switch