Steering Gearbox Removal and Installation: Notes

Special Tools Required 

• Ball joint thread protector, 12 mm 07AAF-SDAA100
• Ball joint remover, 28 mm 07MAC-SL0A202
• Subframe alignment pin 070AG-SJAA10S
• Attachment arm SIL02C000033 *
• Engine hanger balance bar VSB02C000019 *
• Front subframe adapter VSB02C000016 *
• Engine support hanger, A and Reds AAR-T1256 *

* These special tools are available through the Acura Tool and Equipment Program, 888-424-6857

Note these items during removal

• Use solvent and a brush, wash any oil and dirt off the end of the steering gearbox Avoid any electrical parts Blow dry with compressed air
• Be sure to remove the steering wheel before disconnecting the steering joint, or damage to the cable reel can occur
• Lower the front subframe from the body, and remove the steering gearbox through the gap produced by lowering the front subframe