Sunroof / Moonroof Module: Testing and Inspection

Resetting the Moonroof Control Unit

Reset the moonroof after doing any of the following actions:

- The moonroof was moved manually while the battery was dead or disconnected.
- The moonroof motor was removed or replaced with a new one.
- Any components related to the moonroof were replaced or removed and reinstalled.
- Wind deflector
- Moonroof glass
- Moonroof seal
- Moonroof glass bracket
- Moonroof cables, etc.

To reset the moonroof control unit, do these steps:

1. Close all doors, and leave them closed until the procedure is complete.

2. Turn the ignition switch to LOCK (0).

3. Press and hold the tilt switch, and turn the ignition switch to ON (II).

4. Release the tilt switch.

5. Repeat steps 2 to 4 four more times.

6. Check if the AUTO OPEN and AUTO CLOSE functions still work. If they still work, the AUTO functions have not been cleared, go back to step 1. If the AUTO functions have been cleared, go to step 7.

7. Press and hold the moonroof open switch for 3 additional seconds after the moonroof is fully opened.

8. Press and hold the moonroof close switch for 3 additional seconds after the moonroof is fully closed (tilted).

9. Confirm that the moonroof control unit is reset by using the moonroof AUTO OPEN and AUTO CLOSE function.