LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Acura >> 2012 >> RL >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Wiper/Washer Systems >> Wiper System/Washer System >> Wiper/Washer Switch Replacement
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Wiper/Washer Switch Replacement

NOTE: The wiper/washer switch is built into the combination switch control unit. For the wiper/washer test, refer to the combination switch control unit input test (see WIPER/WASHER SWITCH (COMBINATION SWITCH CONTROL UNIT) INPUT TEST ).
  1. Remove the driver's dashboard undercover (see DRIVER'S DASHBOARD UNDERCOVER REMOVAL/INSTALLATION ), and the driver's dashboard lower cover (see DRIVER'S DASHBOARD LOWER COVER REMOVAL/INSTALLATION ), then remove the steering column covers (see STEERING COLUMN REMOVAL AND INSTALLATION ).
  2. Disconnect the combination light switch 12P connector, and dashboard wire harness 8P connector (A) from the wiper/washer switch (B).
    Fig 1: Disconnecting Combination Light Switch 12P Connector And Dashboard Wire Harness 8P Connector From Wiper/Washer Switch
    G07355076Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove the two screws, then slide out the wiper/washer switch.
  4. Install the parts in the reverse order of removal.
scientia non olet · About LEMON Manuals