With SH-AWD

Remove the rear seat cushion (see REAR SEAT REMOVAL/INSTALLATION ).
Remove the access panel (A) from the right side of the floor.

Fig 1: Identifying Access Panel And Fuel Tank Unit 4P Connector (With SH-AWD)
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Disconnect the secondary fuel gauge sending unit 4P connector (B).
Remove the secondary fuel gauge sending unit from the fuel tank .

Measure the resistance between the No. 1 and No. 3 terminals of the secondary fuel gauge sending unit 4P connector with the float at E (EMPTY), 1/2 (HALF FULL), and F (FULL) positions.

Float Position	F 6.9 in (176.1 mm)	1/2 1.3 in (33.3 mm)	E 1.1 in (27.8 mm)
Resistance (Ω)	9 to 11	453.2 to 444.2	453.2 to 444.2

NOTE: Remove the No. 15 BACK UP (10 A) fuse from the under-hood fuse/relay box for at least 10 seconds after completing troubleshooting, otherwise it may take up to 20 minutes for the fuel gauge to indicate the correct fuel level.

Fig 2: Measuring Resistance Between No. 1 And No. 3 Terminals Of Fuel Tank Unit 4P Connector With Float Positions

Courtesy of AMERICAN HONDA MOTOR CO., INC.