April 5, 2026: LEMON Manuals is launched! Read the announcement.

Keyless Access System Registration: Procedure

WARNING: This page is about a different variant/trim than selected.

Keyless Access System - Registration
NOTE:
- Check for aftermarket electrical equipment that could cause problems with keyless access operation.
- While doing the registration, keep the remote away from computers.
- While doing the registration, make sure the doors are closed.
- Programming the remote also programs the keyless transmitter.
- The keyless access control unit can store codes from up to 6 remotes.
When Replacing the Backup Control Unit/Keyless Access Control Unit/PCM/MICU or Registration of the Remote(s)

1. When replacing the keyless access control unit, touch the keyless remote to the engine start/stop button

2. Connect the HDS to the data link connector (DLC)

3. When all remotes are lost, select the ON mode according to the instructions on the HDS screen, then go to step 5

4. Press the engine start/stop button to select the ON mode

5. Select ONE-PUSH START from the SYSTEM SELECTION MENU, then enter REGISTRATION mode

6. Select the appropriate unit or KEYS, and do the registration according to the instructions on the HDS screen

7. Press the engine start/stop button to select the OFF mode, and verify systems work normally with all remotes.

When Replacing the Power Control Unit or the Electric Steering Lock Control Unit

1. Connect the HDS to the data link connector (DLC)

2. Do the registration according to the instructions on the HDS screen

3. After registration, verify all remote related systems work normally with all remotes.