Keyless Access System Registration (2018 2019 2020): Procedure

NOTE: If you replace the keyless access control unit, the vehicle will not turn to the ON mode. Follow the registration procedure of the corresponding unit.

Keyless Access System - Register
NOTE:
- Check for aftermarket electrical equipment that could cause problems with keyless access operation.
- While doing the registration, keep the remote away from computers.
- While doing the registration, make sure the doors are closed.
- Programming the remote also programs the keyless transmitter.
- The keyless access/TPMS control unit can store codes up to 6 remotes.
- When each unit is replaced, such as updating and learning may be necessary in some cases, also make sure the removal and installation procedure of each unit.
When Replacing the Keyless Access/TPMS Control Unit

1. Connect the HDS to the data link connector (DLC).

2. Do the registration according to the instructions on the HDS screen.

3. After registration, verify all remote related systems work normally with all remotes.

When Replacing the TCM

1. Connect the HDS to the data link connector (DLC).

2. Do the registration according to the instructions on the HDS screen.

3. After registration, verify all remote related systems work normally with all remotes, then do the procedure after replacing TCM

.

When Replacing the PCM, MICU or Registration of the Remote (s)

NOTE: If replacing the keyless access/TPMS control unit, register the keyless access control unit first.

1. Connect the HDS to the data link connector (DLC).

2. If all remotes are lost, select the ON mode according to the instructions on the HDS screen, then go to step 4.

3. Turn the vehicle to the ON mode.

4. Select ONE-PUSH START from the SYSTEM SELECTION MENU, then enter REGISTRATION.

5. Select the appropriate items, and do the registration according to the instructions on the HDS screen.

6. After registration, verify the system works normally with all remotes.