When The Power Mirror Switch Operate, The Display Range Is Displayed In An Improper State

- 1.. Turn the vehicle to the ON mode.

- 2. Check for DTCs with the HDS.

Are any DTCs indicated?

YES 

Do the DTC troubleshooting.

NO 

Go to step 2.

- 1.. Check the parameter (s) below with the HDS.

- 2. Check the operating history in the Open to Close history of the power mirror switch and the Close to Open history of the power mirror switch with the HDS.

Is it normal?

YES 

Go to step 3.

NO 

Go to the power mirror switch test .

- 1.. Turn the vehicle to the OFF (LOCK) mode.

- 2. Start the engine.

- 3. Check the camera image on the display when power mirror switch operate.

When the power mirror closed position, does the camera image appear on the display?

YES 

The failure is duplicated. Go to step 4.

NO 

Intermittent failure, the system is OK at this time.

- 1.. Check the multi view camera picture inspection.

Is deviation of the multi view camera system marker on the center display within half?

YES 

Replace the multi view camera unit .

NO 

Do the multi view camera aiming .