DTC P2832: Shift Fork A Position Circuit (Range); DTC P2837: Shift Fork B Position Circuit (Range); DTC P283C: Shift Fork C Position Circuit (Range); DTC P2841: Shift Fork D Position Circuit (Range) (DCT)
NOTE:
- Before you troubleshoot, review the General Troubleshooting Information - Refer to: How to Troubleshoot the Dual Clutch Transmission (DCT) .
- This code is caused by an electrical circuit problem and cannot be caused by a mechanical problem in the transmission.
| DTC Description | Confirmed DTC | Pending DTC | Freeze Frame |
|---|---|---|---|
| P2832 Shift Fork A Position Circuit (Range) | |||
| P2837 Shift Fork B Position Circuit (Range) | |||
| P283C Shift Fork C Position Circuit (Range) | |||
| P2841 Shift Fork D Position Circuit (Range) |
DTC (A/T)
- Problem verification
-1. Turn the vehicle to the ON mode.
- 2. Clear the DTC with the HDS.
- 3. Start the engine in P position/mode, and wait for at least 1 second.
- 4. Check for Pending or Confirmed DTCs with the HDS.
DTC Description Confirmed DTC Pending DTC Freeze Frame P2832 Shift Fork A Position Circuit (Range) P2837 Shift Fork B Position Circuit (Range) P283C Shift Fork C Position Circuit (Range) P2841 Shift Fork D Position Circuit (Range) Is DTC P2832/P2837/P283C/P2841 indicated?
DTC P2832 is indicated
The failure is duplicated. Replace the shift fork A position sensor .
DTC P2837 is indicated
The failure is duplicated. Replace the shift fork B position sensor .
DTC P283C is indicated
The failure is duplicated. Replace the shift fork C position sensor .
DTC P2841 is indicated
The failure is duplicated. Replace the shift fork D position sensor .
NO
Intermittent failure, the system is OK at this time. Check for poor connections and loose terminals between the appropriate shift fork position sensor and the PCM. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.