Specifications Index

RDX COMMON SPECS & PROCEDURES INDEX

System		Specification/Procedure
Air Conditioning
Service		AIR CONDITIONING SERVICE SPECIFICATIONS
Torque		HEATING, VENTILATION, AND AIR CONDITIONING
Axle Nut/Hub Nut
Front		328 N.m (242 ft. lbs.)
Rear		245 N.m (181 ft. lbs.)
Battery		12 VOLT BATTERY AREA
Brakes
Bleeding Sequence		CONVENTIONAL BRAKE SYSTEM BLEEDING
Disc Brakes		FRONT BRAKE DISC INSPECTION or REAR BRAKE DISC INSPECTION
Torque		BRAKES
Charging
Service Specifications		ENGINE ELECTRICAL SERVICE SPECIFICATIONS
Torque		ENGINE ELECTRICAL
Drive Belts
Belt Routing & Adjustment		ALTERNATOR AREA
Engine Cooling
General Service Specifications		ENGINE COOLING SYSTEM SERVICE SPECI FICATIONS
Radiator Cap Pressure		93-123 kPa (0.95-1.25 kgf/cm2, 13.5-17.8 psi)
Thermostat R & I		THERMOSTAT TEST
Water Pump R & I		WATER PUMP INSPECTION
Engine Mechanical
Compression		930 kPa (9.48 kgf/cm² , 134.8 psi) Minimum 200 kPa (2.04 kgf/cm² , 29.0 psi) Maximum variation
Oil Pressure (176°F (80°C)		100kPa (0.71 kgf/cm² , 14.5psi) min. @ idle 400 kPa (5.00 kgf/cm² , 58.0 psi) min. @ 3000 RPM
Overhaul		See applicable specifications tables in ENGINE ELECTRICAL SERVICE SPECIFICATIONS
Torque		ENGINE MECHANICAL
Fluid Specifications		See FLUIDS under MAINTENANCE tab.
Flywheel/Flex Plate Torque		74 N.m (55 ft. lbs.)
Fuel System
Pressure Specification		500-550 kPa (5.1-5.61 kgf/cm² , 72.5-79.8 psi)
Fuel Pressure Test Procedure		FUEL PRESSURE TEST
Ignition
Firing Order & Cylinder Identification		FIRING ORDER & CYLINDER IDENTIFICATION
Spark Plug NGK: 7751
Gap		0.70-0.75 mm (0.0276-0.0295 in)
Torque		22 N.m (16 ft. lbs.)
Starting
Starter		ENGINE ELECTRICAL SERVICE SPECIFICATIONS
Torque		ENGINE ELECTRICAL
Wheel Alignment
Adjustment Specifications		WHEEL ALIGNMENT
	Torque	SUSPENSION
Wheel & Tire
Wheel Lug Nut Torque		108 N.m (80 ft. lbs.)