Repair Procedure: Procedure

A.
NOTE: If you are replacing the driver's airbag after a deployment, refer to Component Replacement/Inspection After Deployment - Refer to: SRS Component Replacement/Inspection After Deployment or Airbag and Tensioner Disposal for a complete list of other parts that must also be replaced.

■ Sub-Procedure

Figure 1

Courtesy of HONDA, U.S.A., INC.

• Removal

NOTE: If you are replacing a deployed driver's airbag, inspect the cable reel for heat damage. If there is any damage, replace the cable reel.
- Remove the springs (a) from the steering wheel. (Figure 1)
  NOTE: Be careful not to damage the steering wheel.
Figure 2

Courtesy of HONDA, U.S.A., INC.

• Installation
- Install the springs (b) to the steering wheel. (Figure 2)
  NOTE: Make sure that the springs are installed properly.
B.
■ Sub-Procedure

• Removal
- With heated steering wheel: Remove the connector (a) from the steering wheel rear cover.
Courtesy of HONDA, U.S.A., INC.