Repair Procedure

How to use this service information .

NOTICE: 

• Clean the disassembled parts with solvent, then dry the disassembled parts with compressed air. Do not wash the rubber parts with solvent.
• When working with a vehicle equipped with the electronic air suspension, be sure to set it to the leveling off mode to prevent unexpected operation. Refer to the Electronic Air Suspension System Service Precautions - Refer to: Electronic Air Suspension System Connector Fitting Precautions or Electronic Air Suspension System Service Precautions for the procedure.

3.0 L Engine 

Courtesy of HONDA, U.S.A., INC.

: Torque, N.m (lbf.ft)

: Replace

: Warning/Caution

: Inspection/Adjustment

*: Learning

: SPL Tool

: Required Removal

3.5 L Engine 

Courtesy of HONDA, U.S.A., INC.

: Torque, N.m (lbf.ft)

: Replace

: Warning/Caution

: Inspection/Adjustment

*: Learning

: SPL Tool

: Required Removal

*1: Without AWD

*2: With AWD

1. A.-

   Sub-Procedure 

   Courtesy of HONDA, U.S.A., INC.

   Installation 

   Specifications 

   Standard Value
   a	3.8 - 4.4 mm (0.150 - 0.173 in)

2. B.-

   Sub-Procedure 

   Figure 1 

   Courtesy of HONDA, U.S.A., INC.

   Removal 

   • Refer to figure 1.

   Figure 2 

   Courtesy of HONDA, U.S.A., INC.

   Installation 

   Specifications (Figure 2) 

   Specification
   a	No Clearance

3. C.-

   Sub-Procedure 

   Figure 1 

   Courtesy of HONDA, U.S.A., INC.

   Removal 

   • Be careful not to damage the bearing support ring (a). (Figure 1)

   Figure 2 

   Courtesy of HONDA, U.S.A., INC.

   Installation 

   Specifications (Figure 2) 

   Specification
   b	No Clearance

4. D.-

   Sub-Procedure 

   Courtesy of HONDA, U.S.A., INC.

   Installation 

   Specifications 

   Standard Value
   a	Flush with Housing