CDS Circuit Inspection

NOTICE: 

Before Disconnecting The SRS Unit Connector, Do The 12 Volt Battery Terminal Disconnection Procedure And Wait For At Least 3 Minutes.

Test Procedure 

• Preparation
• • -

    SRS Unit Connector A (43P): Disconnected

  • -

    Body Control Module Connector B (66P): Disconnected

• Procedure
• • -

    Perform The Inspection According To The Following Table.

(Disconnected)SRS Unit Connector A (43P) female Terminals

(Disconnected)Body Control Module Connector B (66P) female Terminals

IG Mode

Courtesy of HONDA, U.S.A., INC.

Courtesy of HONDA, U.S.A., INC.

Normal Conditions

CDS Open Wire Inspection 

Off

There Is Less Than 1 Ω 

Refer To The Open/Shorted Wire Inspection Description For The Method To Inspect The Shorted Circuit Below, Then Start To Inspect According To Circumstances.

CDS Shorted To Ground Inspection 

Off

There Is More Than 1 MΩ 

Results 

• If Abnormal, There Is A Problem In The Circuit.