DTC B2A60-99: Notes
DTC B2A60-99 : Out of Automatic Correction Range for Misalignment of Multipurpose Camera Unit Image
How to use this service information .
NOTICE:
Before you troubleshoot, review the How to Troubleshoot - Refer to: How to Troubleshoot the Lane Keeping Assist System (LKAS) or How to Troubleshoot the Road Departure Mitigation or How to Troubleshoot the Collision Mitigation Braking System (CMBS) or How to Troubleshoot the Auto High-Beam (High-Beam Support System) or How to Troubleshoot the Adaptive Cruise Control (ACC) .
NOTE:
- This DTC is recorded when the multipurpose camera unit detects an axis misalignment of +/-6.5 deg. or more in the vertical or horizontal direction while driving at a vehicle speed of 12 mph (18 km/h) or higher after turning the vehicle to the ON mode. Even if the multipurpose camera unit is misaligned by more than -6.5 deg. or +6.5 deg., the HDS screen displays values up to -5.12 deg. or +5.08 deg..
- If this DTC is recorded, the following is suspected:
-
- Overload
- Improper installation of the multipurpose camera unit (aging of vehicle, incorrect assembly, etc.).
- The multipurpose camera unit is deformed by a minor collision or strong impact.
- The axis of the multipurpose camera unit is out of alignment due to abnormal wheel alignment, abnormal tire pressure, etc.
- Altered suspension
- After inspecting, repairing, or adjusting a possible cause of the failure, be sure to perform the multipurpose camera aiming procedure. If the DTC cannot be deleted after multipurpose camera aiming, replace the multipurpose camera unit.