Repair Procedure

How to use this service information .

Courtesy of HONDA, U.S.A., INC.

: Torque, N.m (lbf.ft)

: Replace

: Warning/Caution

: Inspection/Adjustment

*: Learning

: SPL Tool

: Required Removal

*1: Part(s) are shown for one side only as the procedure is the same for both sides.

*2: Type A

*3: Type B

1. A.-

   Key Information 

   Do the following before starting your work.

   Disconnect: 

   • Rear Stabilizer Link (Both sides)
   • Rubber Mount - Refer to: Exhaust Pipe/Muffler Area (2.0L Engine) (2024 2025) or Exhaust Pipe/Muffler Area (1.5L Engine) (Type B)

   Sub-Procedure 

   Courtesy of HONDA, U.S.A., INC.

   ■ Installation 

   Installation Directions 

   Position	Direction
   a	Upper Side

   Tightening Procedure 

   Step	Operation	Object	Specification
   1	Temporarily Tighten		Until the bolts are seated on the bushing holder
   2	Tighten	All Bolts	->
   3	Recheck Specified Torque	All Bolts	-

2. B.-

   Preconditions 

   • Vehicle Lifted

   Key Information 

   Do the following before starting your work.

   Remove: 

   • Rear Wheel (Both Sides)
   • Exhaust Pipe/Muffler Area Parts - Refer to: Exhaust Pipe/Muffler Area (2.0L Engine) (2024 2025) or Exhaust Pipe/Muffler Area (1.5L Engine)
   • • -

       Fuel Tank Heat Baffle

     • -

       Muffler

     • -

       Left Muffler (For some models)

   • Rear Suspension Area Parts
   • • -

       Rear Spring (Both sides)

     • -

       Rear Suspension Stroke Sensor (Both sides) (Type-S)

   Disconnect: 

   • Rear Suspension Area Parts
   • • -

       Rear Lower Arm A (Rear Knuckle Side) (Both sides)

     • -

       Rear Lower Arm B (Rear Knuckle Side) (Both sides)

     • -

       Rear Upper Arm (Rear Knuckle Side) (Both sides)

   Sub-Procedure 

   ■ Removal 

   • Support the rear subframe (a) with a wood block (b) and a transmission jack. (Figure 1)

   Tool Details (Figure 1) 

   Name
   c	Transmission Jack (Commercially Available)

   Figure 1 

   Courtesy of HONDA, U.S.A., INC.

   ■ Installation 

   • Refer to figure 2.

   Installation Directions (Figure 2) 

   Position	Direction
   d	Front

   Tightening Procedure (Figure 2) 

   Step	Operation	Object	Specification
   1	Temporarily Tighten	All Bolts	-
   2	Align	Subframe	-
   3	Tighten	All Bolts	-> -> -> -> ->

   Figure 2 

   Courtesy of HONDA, U.S.A., INC.

   After Installation 

   • Wheel Alignment Check