ATP-P Open Wire Inspection

NOTICE: 

Before disconnecting the TCM connector, jump the SCS line with the HDS, and wait more than 1 minute.

Test Procedure 

• Preparation
• • -

    TCM connector (50P) : disconnected

  • -

    Transmission range switch connector (10P) : disconnected

• Procedure
• • -

    Perform the inspection according to the following table.

(Disconnected) TCM connector (50P) female terminals

(Disconnected) Transmission range switch connector (10P) female terminals

IG Mode

Courtesy of HONDA, U.S.A., INC.

Courtesy of HONDA, U.S.A., INC.

Normal Conditions

ATP-P open wire inspection 

OFF

There is less than 1 Ohm 

Results 

• If abnormal, there is a problem in the circuit.