| SRS indicator does not come on |
Symptom Troubleshooting - Refer to: SRS Symptom Troubleshooting - SRS indicator does not come on or SRS Symptom Troubleshooting - Seat belt reminder indicator does not come on, turn off, or flash |
- |
| SRS indicator stays on, but no DTCs are stored, or cannot be read |
NOTE:
If any of the CAN communication failure DTC is indicated in other system, troubleshoot the DTC first.
- Check for open wire or shorted wire in the F-CAN circuit;
-
- -
Between the SRS unit and the CAN gateway (VF-CAN C_H, VF-CAN C_L)
- -
Between the CAN gateway and the gauge control module (IF-CAN_H, IF-CAN_L)
- Check the SRS unit power circuit (+B_SRS, IG1_SRS).
- Check the SRS unit ground circuit (PGND).
- Do the gauge control module self-diagnostic function
.
|
Refer to the followings about the circuit troubleshooting;
|
| Front passenger's airbag cutoff indicator flashes |
Check for DTCs. If any DTC is indicated, go to the DTC troubleshooting |
Front passenger's weight sensor initialization - Refer to: Front Passenger's Weight Sensor Output Check After a Vehicle Collision
or Front Passenger's Weight Sensor Operation Check After Replacing Front Passenger's Seat Component(s)
or Front Passenger's Weight Sensor Initialization |
| Front passenger's airbag cutoff indicator does not come on |
Check for DTCs. If any DTC is indicated, go to the DTC troubleshooting |
DTC B00D5-14 troubleshooting |
| Seat belt reminder indicator does not come on, turn off, or flash |
Symptom Troubleshooting - Refer to: SRS Symptom Troubleshooting - SRS indicator does not come on or SRS Symptom Troubleshooting - Seat belt reminder indicator does not come on, turn off, or flash |
- |