Inspection Outline

• The components to be tested are indicated by a dotted line.
• The illustration does not show all of the areas to be inspected.

Courtesy of HONDA, U.S.A., INC.

• Troubleshoot any DTCs listed or indicated systems below first.
• • PGM-FI System [PGM-FI]: Go to the indicated DTC's troubleshooting - Refer to: Fuel and Emissions Systems DTC Troubleshooting Index(3.0L Engine (USA/Canada models)) or Fuel and Emissions Systems DTC Troubleshooting Index .
  • Body Electrical System (DTCs Related to Power Distribution Module) [Power Distribution Module]: Go to the indicated DTC's troubleshooting .
  • Climate Control System [AC]: Go to the indicated DTC's troubleshooting

NOTICE: 

For more efficient troubleshooting, you may be able to eliminate some inspection items as potential failures based on the conditions of the failure and vehicle.

• Select the HDS [Function test], then do the HDS [A/C CLUTCH], and check the clicking noise from the A/C compressor clutch.
• • Clicking sound is heard from A/C compressor clutch:
  • Clicking sound is not heard from A/C compressor clutch:

Inspection Items		Work Items
a	Climate Control System	Do A/C System Test (Pressure Test) - Refer to: A/C System Contamination Inspection or A/C System Test or A/C System Inspection	o
-	A/C Compressor Clutch	Do the A/C Compressor Clutch Check		o
b	External Circuit	A/C_MG_CLUTCH_RLY_CL- Open Wire Inspection		o
c	PCM	PCM Inspection		o
d	Power Distribution Module	Power Distribution Module Inspection		o