Fog Light Adjustment: Adjustment

How to use this service information .

NOTICE: 

When working with a vehicle equipped with the electronic air suspension, be sure to set it to the leveling off mode to prevent unexpected operation. Refer to the Electronic Air Suspension System Service Precautions - Refer to: Electronic Air Suspension System Connector Fitting Precautions or Electronic Air Suspension System Service Precautions for the procedure.

1. Fog Light - Adjust

   Preconditions 

   • Vehicle on Level Ground
   • Tire Pressures Normal Condition
   • The driver or someone who weighs the same should sit in the driver's seat (or use an equivalent weight).
   • Unload the vehicle.
   • For models with electronic air suspension: With the driver's weight added, reset the suspension by changing the integrated dynamics system mode from Normal to Sport, then back to Normal again.

   Figure 1 

   Courtesy of HONDA, U.S.A., INC.

   Procedure/Specifications 

   1. Park the vehicle in front of a wall or screen (a). (Figure 1)2. Measure the height of the fog lights (b). (Figure 1)3. Turn the fog lights on.

   4. Determine if the fog lights are aimed properly:

   • On the wall or screen, mark the height of the fog lights with a piece of tape (c). (Figure 1)
   • Check each fog light beam's height. Adjust them both so they are approximately 4.5 cm (1.77 in) lower (d) than the height of the fog lights at a distance of 3 m (9.8 ft). (Figure 1)

   Specifications (Figure 1) 

   Position	Distance	Standard Value
   e	1 m (3.3 ft)	-1.5 cm (0.59 in)
   f	2 m (6.6 ft)	-3 cm (1.18 in)
   g	3 m (9.8 ft)	-4.5 cm (1.77 in)

   Figure 2 

   Courtesy of HONDA, U.S.A., INC.

   5. If necessary, adjust each fog light to the specified height by turning the adjuster (h). (Figure 2)