SS1(+), SS2(-) Open Wire Inspection

Test Procedure 

• Preparation
• • -

    Engine start/stop switch 10P connector: disconnected

  • -

    Body control module connector C (66P): disconnected

• Procedure
• • -

    Perform the inspection according to the following table.

(Disconnected) Engine start/stop switch 10P connector female terminals

(Disconnected)Body control module connector C (66P) female terminals

IG Mode

Courtesy of HONDA, U.S.A., INC.

Courtesy of HONDA, U.S.A., INC.

Normal Conditions

SS1(+) open wire inspection 

OFF

There is less than 1 Ohm 

SS2(-) open wire inspection 

OFF

There is less than 1 Ohm 

Results 

• If abnormal, there is a problem in the circuit.