Servotronic, assembly overview: Notes

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2005 Audi allroad, 2004 Audi allroad, 2004 Audi A6, 2003 Audi allroad, and 2003 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.

The following list pertains to Fig 1.

Power steering gear with tie rods
- Assembly Overview, see POWER STEERING GEAR, ASSEMBLY OVERVIEW
Connector for servotronic
Relay carrier, 13-pin
- Located under trim in driver's footwell
  See appropriate System Wiring Diagrams article.
- Relay for servotronic control module - J236- (position 13)
- Checking voltage supply, see SERVOTRONIC, CHECKING VOLTAGE SUPPLY
- Checking speed signal, see SPEED SIGNAL, CHECKING
Socket-head bolt, 3 Nm
- 2.5 mm
NOTE: Do not open Torx bolts!
Servotronic solenoid valve - N119-
- Steering gear must be removed to replace servotronic valve.
- Checking, see SERVOTRONIC VALVE, CHECKING
NOTE: DO NOT open Torx bolts!
Seal
- Always replace
Seal
- Always replace
Sieve
- Always replace

Fig 1: View Of Servotronic Assembly

Courtesy of AUDI OF AMERICA, INC.