TID $05 (05): Tank Ventilation System, Tank Leak Test
- Connect the scan tool.
- Start the engine and run at idle.
- Select "Mode 6: Check test the results of components that are not continuously monitored".
Select "Test-ID 05 ($05)".
- Select the desired "Component-ID (TID)" or "Hex-ID".
- Check specified values at idle.
| Component-ID (CID) (Hex-ID) | DTC | Component or System | Min. | Max. | Additional Information |
|---|---|---|---|---|---|
| 0D ($13) | P0442 | Pressure Check. Small leak test. | --- | 1.85-2.05 seconds | Refer to DTC P0442 in the OBD DTC Summary Table. P0442 . |
| 0D ($13) | P0455 | Pressure Check. Large leak test. | --- | 0.95 seconds | Refer to DTC P0455 in the OBD DTC Summary Table P0455 . |
| 11 ($17) | P0456 | Pressure Check. Pinhole leak test. | --- | 2.05-7 seconds | Refer to DTC P0456 in the OBD DTC Summary Table P0456 . |
- If any of components or systems fail to meet the specified values. Refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTCs or the corresponding diagnostic repair procedure → Mode 03: Interrogating fault memory .
- Switch the ignition off.
- End of diagnosis.