LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Audi >> 2008 >> TT Base, 2D Convertible >> Repair and Diagnosis >> General Information >> Reset Procedures >> Tire Pressure Monitor Systems >> TPMS Reset Procedures >> Wheel Change Initialization
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Wheel Change Initialization

NOTE: If a tire or tire pressure sensor was changed, or tires rotated, the TPMS must be initialized.
  1. Adjust air pressure in all tires to specifications (provided on tire pressure label located inside fuel filler door/B pillar).
  2. Turn ignition ON.
  3. Vehicle must be stationary.
  4. Press the Tire Pressure Monitoring button on the center console switch strip for approximately 5 seconds or until a signal tone is heard and the yellow malfunction light in the instrument cluster flashes several times.
  5. The vehicle must now be stationary for 20 minutes and then be driven on a 3 minute initialization drive at speeds greater than 16 mph (25 K/ph).
    NOTE: The system will detect a malfunction if the control module is not ready for initialization because the 20 minute standing time was not followed. The system will only initialize the tire pressure sensors automatically after a 20 minute standing time.
scientia non olet · About LEMON Manuals