Abs Hydraulic Unit With Abs Control Module Assembly Overview
- ABS Hydraulic Unit -N55- with ABS Control Module -J104-
- Component location: In left of the engine compartment.
- Removing and Installing ABS HYDRAULIC UNIT WITH ABS CONTROL MODULE .
- The hydraulic control unit is comprised of the ABS Hydraulic Unit -N55- with integrated Brake Pressure Sensor 1 -G201- and ABS Control Module -J104-.
- The components must not be separated from each other.
- Do not disconnect connector before successfully completing OBD.
- Switch ignition off before disconnecting connector.
- The Brake Pressure Sensor 1 -G201- is integrated into ABS Hydraulic Unit -N55- and cannot be replaced.CAUTION:
The ABS Hydraulic Unit -N55- and ABS Control Module -J104- must not be separated from each other.
- ESP bracket
- The bracket cannot be removed.
- ABS control module J104 electrical connector
- Brake line
- To brake master cylinder.
- 14 Nm
- Brake line
- To brake master cylinder.
- 14 Nm
- Brake lines
- Hydraulic unit to right front brake caliper
- 14 Nm
- Hydraulic unit to left front brake caliper
- 14 Nm
- Hydraulic control unit to left rear brake caliper
- 14 Nm
- Hydraulic control unit to right rear brake caliper
- 14 Nm