Section 2 (3.2L - Fuel Injection Ignition, Engine Code(S): BKH)
WARNING: This page is about a different variant/trim than selected.
- 24 - Fuel injection system
- Simos Fuel Injection System, Servicing
- Safety precautions
- Rules of cleanliness for performing work on fuel injection system
- Procedure that must be performed before opening the high-pressure fuel injection system. Pay close attention!
- Technical data
- Component location, overview
- Engine compartment, right side
- Engine compartment, left side
- Component location SIMOS Control Module J361
- Location Throttle Position (TP) Sensor G79/Accelerator Pedal Position Sensor 2 G185
- Installed location Brake light switch F/Brake pedal switch F47 , Clutch pedal switch F36
- Clutch Pedal Starter Interlock Switch F194
- Right holder for connectors on bulkhead
- Left holder for connectors on bulkhead
- Oxygen sensors location, cylinder bank 1 (right)
- Oxygen sensors location, cylinder bank 2 (left)
- Electrical connectors on right rear of engine
- Electrical connectors on left rear of engine
- Hall sensor and valve for camshaft adjustment, bank 1
- Hall sensor and valve for camshaft adjustment, bank 2
- Low Fuel Pressure Sensor G410 installation location
- Component location front on engine
- Component location on rear of intake manifold
- Component location on the high pressure pump
- Left Electro-Hydraulic Engine Mount Solenoid Valve N144 or Right Electro-Hydraulic Engine Mount Solenoid Valve N145 installation location
- Component location under intake manifold, cylinder bank 1 (right)
- Component location under intake manifold, cylinder bank 2 (left)
- Location Engine Speed (RPM) Sensor G28
- Air filter, component overview
- Air filter element, removing and installing
- Intake manifold upper-part, component overview
- Intake manifold upper-part, removing and installing
- Intake manifold lower-part, component overview
- Intake manifold lower-part with fuel rail, removing and installing
- Fuel injectors, removing and installing
- Fuel pressure and residual pressure before high pressure pump, checking
- High pressure pump, removing and installing
- Fuel system, bleeding
- Wiring and components, checking with Test box V.A.G 1598/42
- Engine Control Module (ECM), removing and installing
- Oxygen sensor before catalytic converter, bank 1 (right side), removing and installing
- Oxygen sensor before catalytic converter, bank 2 (left side), removing and installing
- Oxygen sensor behind catalytic converter, bank 1 (right side), removing and installing
- Oxygen sensor behind catalytic converter, bank 2 (left side), removing and installing
- Simos Fuel Injection System, Servicing
- 28 - Ignition system