Fuel Injectors: Notes
Special tools and workshop equipment required
- Tool Set T10133
NOTE:
The puller T10133/2 was changed and is now called the puller T10133/2-A. If the new tool is not available, the old one can be modified.
Modify puller T10133/2 to create the puller T10133/2-A.
Special tools and workshop equipment required
- Round file approximately 6 mm
-- File the semi-circle as shown in the illustration (See Fig 1). The semi-circle allows the tool to slide farther onto the fuel injector, thus providing the tool with a larger contact surface.
-- Mark modified tool with an "A" at the end of the tool number.
High Pressure Fuel Injector, Assembly Overview
- Radial adjustment - Replace if damaged
- Combustion chamber seal (Teflon seal) - replace, the seal must not be greased or be handled with any other lubricant during installation
- Groove on fuel injector
- Spacer ring - Replace if damaged
- O-ring - replace, lightly coat with clean engine oil during installation
- Support ring - fuel rail wields force via the support ring to hold the fuel injector tightly in the cylinder head