Rearview Camera System Control Module -J772-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2015 Audi A7 Quattro and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Turn off the ignition and all electrical consumers and remove the ignition key.

-- Remove the right luggage compartment side trim panel. Refer to LUGGAGE COMPARTMENT SIDE TRIM PANEL, REMOVING AND INSTALLING .

The bracket must be removed first in order to be able to remove the Rearview Camera System Control Module -J772-. It is attached with screws to the relay and fuse panel inside the luggage compartment on the right side. The relay and fuse carrier in the luggage compartment on the right side must first be removed. Refer to LUGGAGE COMPARTMENT RELAY AND FUSE CARRIER AND CONTROL MODULES OVERVIEW .

Removing the bracket

-- Unlock and disconnect all of the connectors from the control modules.

-- Remove the nuts -arrows- and remove the bracket -1- along with the control modules from the luggage compartment recess.

Fig 1: Removing Nuts -Arrows- And Remove Bracket -1-

Courtesy of AUDI OF AMERICA, LLC

The Rearview Camera System Control Module -J772- -1- is only clipped into the bracket -2-.

Fig 2: Disconnecting Connectors From Rearview Camera System Control Module -J772- -1-

Courtesy of AUDI OF AMERICA, LLC

-- Release and disconnect the connectors from the Rearview Camera System Control Module -J772- -1-.

-- Press the retainer downward and remove the Rearview Camera System Control Module -J772- -1- from the bracket -2-.