LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Audi >> 2012 >> A8 Base >> Repair and Diagnosis (Single Page) >> Transmission >> Automatic Trans >> 4.2L - Generic Scan Tool - Engine Code: CDRA (1 Of 2) >> St Generic Scan Tool >> Diagnosis And Testing >> Diagnostic Modes 01 - 0A >> Diagnostic Mode 06 - Read Test Results For Specific Diagnostic Functions >> Monitor-ID $A4 (164) : Mis-Fire Cylinder 3 Data
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Monitor-ID $A4 (164) : Mis-Fire Cylinder 3 Data

-- Connect the scan tool.

-- Start the engine and run at idle.

-- Select "Mode 6: Check test the results of components that are not continuously monitored".

Select "Monitor-ID A4".

-- Select the desired "Test-ID (TID)" or "Hex-ID".

-- Check specified values at idle.

Test-ID (TID) (Hex-ID) DTC Component or System Min./Max. Values Additional Information
11 ($0B) P0303 Misfire cylinder 3, Average value over 10 Driving Cycles. For additional information, refer to the Bosch Motronic MED 17.1 OBD System Strategy. 0 - 65535 (counts) Refer to DTC P0303 in the DTC summary table. Engine Control Module --, 2010-2012 => P0303 .
12 ($0C) P0303 Misfire cylinder 3, in this Driving Cycle. For additional information, refer to the Bosch Motronic MED 17.1 OBD System Strategy. 0 - 65535 (counts) Refer to DTC P0303 in the DTC summary table. Engine Control Module --, 2010-2012 => P0303 .

-- If any of components or systems fail to meet the specified values. Refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTC or the corresponding diagnostic repair procedure DIAGNOSTIC MODE 03 - READ DTC MEMORY .

-- Switch the ignition off.

scientia non olet · About LEMON Manuals