Left Engine Mount, Removing And Installing: Installing
Install in reverse order of removal. Note the following:
Replace any bolts that were tightened with an additional turn.
When installing, bring all cable ties back to same positions.
-- Align the subframe and using the marks made on longitudinal members during removal.
-- Tighten the subframe bolts only to the tightening specifications, do not tighten them further (tighten the bolts only after axle alignment), refer to Subframe .
Risk of accident due to loose connections.
- If the bolts in the subframe are not tightened to final torque, vehicle must not be driven.
-- Install the brace on the transmission mount.
-- Attach the steering intermediate shaft to the steering gear, refer to Steering .
-- Install the ATF lines, refer to [For transmission(s) 0BK] ATF Circuit .
-- Install the wires and Terminal 30 Wire Junction 2 -TV22-, refer to Relay Panels, Fuse Panels and E-BoxesRelease Tool Set VAS1978/35 and appropriate SYSTEM WIRING DIAGRAMS information.
-- Follow all steps after connecting the battery, refer to Battery, Starter, Generator, Cruise Control .
-- Install the air filter housing, refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .
-- Install the engine cover, refer to ENGINE COVER, REMOVING AND INSTALLING .
-- Perform an axle alignment, refer to Vehicle Alignment .
Risk of accident due to loose connections.
- Tighten the subframe bolts to the specification after performing axle alignment.