ATEQ TPMS Reset Procedure
NOTE:
On Audi vehicles, the TPMS3 cannot be used to register the TPMS sensors, or reset the TPMS.
NOTE:
In order for the TPMS to work, the specified pressures (provided on tire pressure label) must be reprogrammed after every change in air pressure.
NOTE:
Whenever tire pressure is adjusted (i.e., when readjusting tire pressure for a load condition), or after every wheel change, the adjusted pressure has to be stored again.
NOTE:
The correct saving of the specified values is a basic requirement for accurate tire pressure monitoring.
CAUTION:
Only use the VAS 5051B on this vehicle.
- Adjust air pressure in all tires to specifications.
- Connect Vehicle Diagnosis and Service System VAS 5051B with corresponding diagnostic cable to vehicle.
- Turn ON Vehicle Diagnosis and Service System.
- Vehicle Diagnosis and Service System is ready when it displays operating modes in the button fields.
- Turn ignition ON.
- Select "GUIDED FUNCTIONS" on screen.
- Select "TIRE PRESSURE MONITORING SYSTEM J502", and then "CODING CONTROL MODULE".
- Follow the on screen instructions.