LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Audi >> 2013 >> A4 Base >> Repair and Diagnosis >> Transmission >> Transmission Control Systems >> 2.0L - Generic Scan Tool - Engine Code(S): CPMA & CPMB (1 Of 2) (Sedan) >> St Generic Scan Tool >> Diagnosis And Testing >> Diagnostic Modes 01 - 0A >> Diagnostic Mode 06 - Read Test Results For Specific Diagnostic Functions (My 2015) >> Monitor-ID A2 ($A2): Mis-Fire Cylinder 1 Data
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Monitor-ID A2 ($A2): Mis-Fire Cylinder 1 Data

-- Connect the scan tool.

-- Start the engine and run at idle.

-- Select "Mode 6: Check test the results of components that are not continuously monitored".

Select "Monitor-ID A2 ($A2)".

-- Select the desired "Test-ID (TID)".

-- Check specified values at idle.

Test-ID (TID) DTC Component or System Min./Max. Values Additional Information
$0B P0301 Misfire Cylinder 1, Average value over 10 Driving Cycles. 0 - 65, 535 (counts) Refer to DTC P0301 in the DTC summary table.Engine Control Module --, 2015 MY => P0301
$0C P0301 Misfire Cylinder 1, in this Driving Cycle. 0 - 65, 535 (counts) Refer to DTC P0301 in the DTC summary table.Engine Control Module --, 2015 MY => P0301

-- If any of components or systems fail to meet the specified values. Refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTC or the corresponding diagnostic repair procedure DIAGNOSTIC MODE 03 - READ DTC MEMORY .

-- Switch ignition OFF.

scientia non olet · About LEMON Manuals