Monitor-ID ($3D): EVAP Valve Function Check
-- Connect the scan tool.
-- Start the engine and run at idle.
-- Select "Mode 6: Check test the results of components that are not continuously monitored".
Select "Monitor-ID ($3D)".
-- Select the desired "Hex-ID".
-- Check specified values at idle.
| (Hex-ID) | DTC | Component or System | Min. | Max. | Additional Information |
|---|---|---|---|---|---|
| $80 | P0441 | Tank vent valve check, Active test Air balance at idle OK. | 0.2000 | 1.999 | Refer to DTC P0441 in the DTC table. Engine Control Module --, 2012-2014 MY => P0441 . |
| $88 | P0441 | Tank vent valve check, Active test, Oxygen sensor deviating in lean direction (can only test OK). | 1.0 (counts) | 65535 (counts) | Refer to DTC P0441 in the DTC table. Engine Control Module --, 2012-2014 MY => P0441 |
| $89 | P0441 | Tank vent valve check, Active test, Oxygen sensor deviating in lean direction (can only test OK). | 1.0 (counts) | 65535 (counts) | Refer to DTC P0441 in the DTC table. Engine Control Module --, 2012-2014 MY => P0441 |
-- If any of components or systems fail to meet the specified values. Refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTC or the corresponding diagnostic repair procedure DIAGNOSTIC MODE 03 - READ DTC MEMORY .
-- Switch the ignition off.