Power Steering System, Checking For Leaks And Checking Fluid Level And Filling
High Voltage System Warning Messages:
Working When the Ignition May Not Be On, refer to WORKING WHEN THE IGNITION MAY NOT BE ON .
Do not let the engine run.
The front wheels pointing straight ahead.
Cold Fluid (approximately 70 °F (20°C):
-- Remove cover.
-- Clean dipstick with clean cloth.
-- Screw cap on hand-tight and remove again.
Screw cap fully in to get an accurate fluid level reading.
-- Check the oil level: The oil level must be within the -B- range.
Warm Fluid (approximately 176 °F (80°C):
-- Remove cover.
-- Clean dipstick with clean cloth.
-- Screw cap on hand-tight and remove again.
Screw cap fully in to get an accurate fluid level reading.
-- Check the fluid level: The fluid level must be within the -A- range.
If oil level is above specified range, fluid must be extracted off.
Do not use extracted power steering fluid.
If the fluid level is below the specified level, check the power steering system for leaks (repair measure). It is not sufficient just to add fluid.