Overview - Final Drive: Notes
- Torque Converter
- Overview. Refer to .
- Shaft Seal
- For the torque converter
- Shaft Seal
- For the left flange shaft
- Between the final drive and the transmission housing
- Replacing. Refer to LEFT SEAL, REPLACING .
- Shim
- Behind the taper roller bearing outer race
- Taper Roller Bearing Outer Race
- Bolt
- Tightening specification and sequence. Refer to Figure.
- Shaft Seal
- For the right flange shaft
- Replacing. Refer to RIGHT SEAL, REPLACING .
- Circlip
- Always replace
- Right Flange Shaft
- Removing and Installing. Refer to RIGHT FLANGE SHAFT, REMOVING AND INSTALLING .
- Plug
- For the inspection and fill hole
- For the gear oil inside the front final drive
- Tightening Specification. Refer to Drain and Sealing Plug .
- Cover
- For the front final drive
- Pay attention to the alignment sleeves
- Shim
- Behind the taper roller bearing outer race
- Taper Roller Bearing Outer Race
- O-ring
- On the front final drive cover
- Removing and Installing. Refer to O-RING ON FRONT FINAL DRIVE COVER, REMOVING AND INSTALLING .
- Differential
- Transmission
- Spring Pin
- Removing and Installing. Refer to SELECTOR SHAFT SEAL, REPLACING .
- Shift Lever
- Removing and Installing. Refer to SELECTOR SHAFT SEAL, REPLACING .
- Shaft Seal
- For the shift lever
- Replacing. Refer to SELECTOR SHAFT SEAL, REPLACING .
- Left Flange Shaft
- Removing and Installing. Refer to LEFT FLANGE SHAFT, REMOVING AND INSTALLING .
- Bolt
- 9 Nm +60°
- Always replace
- Gear Carrier
- Use the clip -item 24- OVERVIEW - FINAL DRIVE => List Item:Retainer to attach together with the mount -item 23- OVERVIEW - FINAL DRIVE => List Item:Bearings to the left flange shaft.
- Is identified together as the left flange shaft mounting bracket.
- Bearings
- For the left flange shaft
- Retainer
- For the left flange shaft bearing