Engine Mount
WARNING: This page is about a different variant/trim than selected.
- Not Installed
- Bolt
- 20 Nm
- Retaining Plate
- For the engine mount
- If the engine mount is faulty, replace the retaining plate
- Check the retaining plate on the opposite side; replace if necessary
- Not Installed
- Not Installed
- Bolt
- 40 Nm
- Engine Support
- Bolt
- 10 Nm
- Heat Shield
- Bolt
- 90 Nm +90°
- Always replace after removing
- Engine Mount
- Depending on the transmission with the Left Electrohydraulic Engine Mount Solenoid Valve -N144-, Right Electrohydraulic Engine Mount Solenoid Valve -N145-
- Removing and installing. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .
- Subframe
- Bolt
- 55 Nm