Distance Regulation Control Module - J428- Clip, Replacing: Procedure

Distance Regulation Control Module - J428- removed from the retaining plate.

Place a screwdriver between the hook and the housing.
Bend every hook all the way around with the screwdriver until it audibly breaks off.

To prevent the broken hook from getting caught on the housing, remove it from the inside of the clip using needle nose pliers.

Courtesy of AUDI OF AMERICA, LLC

Insert the new clip in the hole in the housing, as shown and push in by hand until it clicks into place.

The tabs on the clip must sit correctly in the recesses.
- Install the stud bolt.
The stud bolt must be aligned correctly to the clip.

Courtesy of AUDI OF AMERICA, LLC
- Turn the stud bolt into the distance regulation control module up to the dimension -a-.
- Measure the dimension -a- at all stud bolts using the Digital Caliper - VAS6335- and correct if necessary.
Dimension -a- = 17.6 mm.

Courtesy of AUDI OF AMERICA, LLC

8