Rearview Camera -R189-, CALIBRATING: Notes

Special tools and workshop equipment required

-- Establish the requirements. Refer to Calibration Tool .

-- Connect the Vehicle Diagnostic Tester.

:VAS6350/1 Installing

-- Check the dimension of the holes.

-- Equip the :VAS6350/1 appropriately. Use spacer pieces. For rims with a large offset (RS 6) use the :VAS6350/5 .

-- To do so, secure the three wheel bolt adapters in the hole circle to each :VAS6350/1 .

-- Place the paddle on both :VAS6350/1 and secure them using a clamping screw.

-- Place the :VAS6350/1 onto the wheel bolts on the rear wheels.

The :VAS6350/1 are positioned by the "O-rings" in the adapters and secured.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Attach the :VAS6350/1 onto the wheels so that any installed "anti-theft" wheel bolts are not connected to the :VAS6350/1 .

-- Adjust the paddles with the aid of clamping screw so that they move freely just above the floor. Check the paddles for ease of movement.

-- Install and align the :VAS6350A . Refer to Calibration Tool .