Service Interval Display, Resetting Service Event

CAUTION:

Risk of injury due to unintended engine start on high-voltage vehicles!

Pay attention to the high-voltage system warning messages:
For procedures where the ignition must be switched off, refer to PROCEDURES THAT NEED IGNITION SWITCHED ON .

Procedure:

-- Connect the Vehicle Diagnostic Tester. Refer to VEHICLE DIAGNOSTIC TESTER, CONNECTING .

-- Select Diagnostic mode and start the diagnosis.

-- Perform the vehicle identification.

-- Deselect " Working with Guided Fault Finding " by removing v and pressing Accept .

-- Switch to the "Special functions " tab.

-- Service Interval, Resetting with ODIS (select the corresponding service).

-- Start the program using Perform test... .

-- Continue the program sequence.

NOTE:

Refer to the appropriate service information for which service channel to reset and for what data to enter.