AWD Vehicles, Checking

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2022 Audi S5 Sportback, 2022 Audi RS 5 Sportback, 2022 Audi A5 Sportback, 2021 Audi S5 Sportback, and 2021 Audi RS 5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.

TIP:

Pay attention to the instructions on the test stand screen.

Test On a One-Axle Roller Test Stand

NOTE:

Only check the brakes and the front and rear axle with the "engine off".

Always switch off the engine during a brake inspection on the one-axle roller test stand to prevent generating drive from one axle to another.

Only star the engine to create the necessary brake pressure for the brake inspection.

Then switch of the engine again.

Test Sequence:

The operation takes place on a test stand.
For vehicles with manual transmission engage idle.
On vehicles with an automatic or DSG transmission engage the "N" gear.
During this test, the wheels of one axle are driven in opposite directions, to prevent delivering power to the other axle.
The test speed must not exceed 6 km/h, otherwise the brakes may lock up due to the roller start-up delay (EDL regulation).
Test stands approved by Audi meet these requirements.