Generic Scan Tool (DMSA,DNVB) (2022) (1 Of 2)
- St Generic Scan Tool
- General Information
- Description And Operation
- Notes
- On Board Diagnostic Systems
- Evaporative Emission System
- Electronic Throttle Control (Etc) System
- Electronic Power Control (EPC) Warning Lamp
- Engine Control Module (ECM)
- Malfunction Indicator Lamp (Mil)
- Controller Area Network (Can)
- Fuel Supply
- Ignition And Timing
- Variable Valve Timing
- Exhaust-Gas RECIRCULATION (EGR) System
- Secondary Air Injection
- Exhaust Systems
- Diagnosis And Testing
- Notes
- Preliminary Check
- Readiness Code
- Diagnostic Modes 01 - 0A
- Notes
- Diagnostic Mode 01 - Read Current System Data
- Diagnostic Mode 02 - Read Operating Conditions
- Diagnostic Mode 03 - Read DTC Memory
- Diagnostic Mode 04 - Erase DTC Memory
- Diagnostic Mode 05 - Read Oxygen Sensor Monitoring Test Results
- Diagnostic Mode 06 - Read Test Results For Specific Diagnostic Functions, 2022 My
- Notes
- Monitor-ID $01: Exhaust Gas Sensor Monitor Bank 1 - Sensor 1
- Monitor-ID $02: Exhaust Gas Sensor Monitor Bank 1 - Sensor 2
- Monitor-ID $21: Catalyst Monitor Bank 1
- Monitor-ID $35: VVT Monitor Bank 1
- Monitor-ID $3C: EVAP Monitor (0.020" / 0.5 mm)
- Monitor-ID $3D: Purge Flow Monitor
- Monitor-ID $41: Exhaust Gas Sensor Heater Monitor Bank 1 - Sensor 1
- Monitor-ID $42: Exhaust Gas Sensor Heater Monitor Bank 1 - Sensor 2
- Monitor-ID $81: Fuel System Monitor Bank 1
- Monitor-ID $A2: Misfire Cylinder 1 Data
- Monitor-ID $A3: Misfire Cylinder 2 Data
- Monitor-ID $A4: Misfire Cylinder 3 Data
- Monitor-ID $A5: Misfire Cylinder 4 Data
- Diagnostic Mode 07 - Read Faults Detected During The Current Or Last Driving Cycle
- Diagnostic Mode 08 - Request Control Of On-Board System, Test Or Component
- Diagnostic Mode 09 - Read Vehicle Information
- Diagnostic Mode 0A - Check Permanent DTC Memory