Additional Safety Precautions For Airbag Control Module

CAUTION:

After every removal and installation of the Airbag Control Module - J234-, the Guided Function "Inertial sensor basic setting" must be performed.
If the Airbag Control Module -J234- is replaced with a new part, the basic setting is performed when implementing the "15 - Replace airbag control module" program.
If the Airbag Control Module -J234- is removed and then the same one is reinstalled, perform the "inertial sensor basic setting" as follows:

-- Connect the Vehicle Diagnostic Tester.

-- Switch the ignition on.

-- Select and start the Diagnostic operating mode.

-- Select the Test plan tab.

-- Select the Select individual test button and select the following tree structure consecutively:

-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.