Driver Assistance Systems Front Camera, Calibrating: Notes
WARNING: This page is about a different car, the 2025 Audi SQ7 and 2025 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
There are two choices for calibrating:
The "complete alignment"
This procedure should be selected for the following activities if a wheel alignment and calibration/adjustment should be performed.
- Rear axle toe/camber was adjusted.
The "quick access"
This procedure should be selected for the following activities if only the calibration/adjustment will be performed.
- The installation position of the Driver Assistance Systems Front Camera -R242- was changed in the vehicle.
- The connector for the Driver Assistance Systems Front Camera - R242- was touched.
TIP:
- Both procedures are programmed in the wheel alignment computer. The respective procedure is performed automatically. It is only necessary to select the appropriate program for the procedure that will be performed.
- If only the calibration/adjustment of the driver assistance systems front camera should be performed, select the "quick start" mode on the wheel alignment computer.
- The procedure in the "quick access" mode is described in the following.
Special tools and workshop equipment required
- Wheel Alignment Computer approved by VW/Audi
- Vehicle Diagnostic Tester
- Wheel Alignment Computer - Camera :VAS 701 001/1
- Setting Device - Basic Set :VAS 6430/1A
- Adapter VAS 6430/9 :VAS 6430/9 , only for surface mounted hoist with a dimension greater than 300 mm.