Section 3097 (Front Axle - Repair)
WARNING: This page is about a different car, the 2011 BMW 750xi, 2011 BMW 750Lxi, 2010 BMW 750xi, and 2010 BMW 750Lxi. However, it is still accessible from the selected car via links, so may be relevant.
- General
- 00 Danger of poisoning if oil is ingested/absorbed through the skin
- 31 00... Front axle + steering: wheel/chassis alignment check must be carried out after the following work
- 31..... Front axle overview
- 31 00... Information on replacing shock absorbers
- 31 00... Instructions (chassis components made of aluminium)
- 00..... Lifting the vehicle using a vehicle hoist
- 31 00 Mobile table lift
- 31 00... Notes
- 41 00... Notes on repairing threads
- 31 00... Notes on repairing threads
- 31..... Overview of front axle differential/output shafts
- 00..... Raising vehicle with trolley jack
- 00 Risk of injury if oil comes into contact with eyes and skin
- 00 Safety information for working on vehicles with automatic engine start-stop function (MSA)
- 00 Safety instructions for handling oil
- Underbody Protection
- Front Sub-Frame
- Struts With Rubber Mounts
- 31 12 003 Removing and installing / replacing top right wishbone
- 31 12 004 Removing and installing/replacing bottom left or right control arm (all-wheel drive vehicle)
- 31 12 050 Removing and installing/replacing left or right trailing link (all-wheel drive vehicle)
- 31 12 002 Removing and installing/replacing top left wishbone
- 31 12 134 Replacing rubber mount in left or right trailing link
- 31 12 138 Replacing rubber mounts on both trailing links
- Wheel Bearings And Stub Axle
- Spring Strut
- Spring With Suspension
- Stabilizer Bar
- Front Axle Gearbox
- 31 50... Check/change front axle differential oil
- 31 50 001 Removing and installing/replacing front axle differential
- 31 51 060 Replacing O-ring for front axle differential on right
- 31 51 010 Replacing radial seal for drive flange of front axle differential
- 31 51 015 Replacing shaft seal for left output shaft
- Differential With Bearings
- Output Shaft
- 31 60... Notes on removing and installing Low Profile band clamps
- 31 60 005 Removing and installing/replacing both output shafts
- 31 60 000 Removing and installing/replacing left or right output shaft
- 31 60 530 Replacing an output shaft gaiter (on transmission side) (output shaft removed)
- 31 51 015 Replacing shaft seal for left output shaft
- 31 51 020 Replacing shaft seal for right output shaft
- 31 60 535 Replacing two gaiters on output shaft(s) (output shaft(s) removed)